Edgebanding Inside Corners - Grizzly G0825 Owner's Manual

Edgebanding Inside
Corners
The included inside corner plate is used when
applying edgebanding tape to an inside corner
of a workpiece. The inside corner plate applies
pressure to the edgebanding tape in 90º corners.
To perform an inside corner edgebanding
operation:
1. Attach corner plate to base plate mounting
hole next to outfeed roller (see Figure 22)
using cap screw pre-installed in corner plate.
Figure 22. Connecting corner plate.
2.
Allow edgebander to preheat, then position
corner plate into inside corner (see Figure
23).
Inside
Corner
Figure 23. Aligning corner plate to inside corner.
Model G0825 (Mfd. Since 02/17)
Corner
Plate
3. Trim edgebanding
workpiece edge length, leaving a small
amount of excess to trim after banding it
applied.
4.
With corner plate in inside corner of workpiece,
feed edgebanding tape through edgebander
until leading edge contacts inside corner of
workpiece, as shown in Figure 24.
Workpiece
Corner
Edgebanding
Tape
Figure 24. Edgebanding tape contacting inside
corner.
5. Move edgebander away from inside corner
of workpiece until operation is complete (see
Figure 25).
Figure 25. Inside corner edgebanding operation.
tape according
Corner Plate
Corner Plate
-23-
to