Table of Contents
Advertisement
Controls &
Components
To reduce your risk of
serious injury, read this
entire
using machine.
Refer to the following figures and descriptions to
become familiar with the basic controls and com-
ponents of this machine. Understanding these
items and how they work will help you understand
the rest of the manual and minimize your risk of
injury when operating this machine.
Component Descriptions
B
A
G
F
Figure 1. Edgebander components (front).
A. Infeed Guide: Directs edgebanding tape
between feed roller and glue roller.
B. Tension Dial: Adjusts edgebanding tape ten-
sion to evenly distribute glue during opera-
tion.
C. Feed Roller ON/OFF Button: Turns feed
rollers ON once glue pot is heated. Feed
roller will not activate if glue pot temperature
is below 250°F (120°C).
D. Feed Rate Control Dial: Adjusts edgeband-
ing tape feed rate between 6.5–20 FPM.
-4-
manual
BEFORE
C
D
E
E. Master Power Switch: Allows power to
machine.
Note: Glue pot heater unit does not automati-
cally activate when Master Power Switch is
turned ON. Heating Unit ON/OFF Button (see
Page 5) must also be pressed to heat glue
pot.
F.
Control Panel: Illuminates when Master
Power Switch is turned ON (see Page 5 for
detailed Control Panel functions).
G. Tape Dispenser: Holds edgebanding tape
rolls during operation.
H
M
L
Figure 2. Edgebander components (rear).
H. Guide Plate Lock: Secures guide plate
height for operation.
I.
Feed Roller: Feeds edgebanding tape into
glue roller while applying pressure.
J.
Glue Dial: Adjusts amount of glue applied to
edgebanding.
K. Heated Fence: Houses glue spindle and
edgebanding tape pressure plate.
L.
Glue Pot Cover: Features a viewing window
to verify glue pot level. Unscrew lock handle
to refill glue.
M. Guide Plate: Adjusts to maintain even appli-
cation of edgebanding tape to workpiece.
Locks in place with guide plate lock (H).
Features handle for two-handed operation.
Model G0825 (Mfd. Since 02/17)
I
J
K
Advertisement
Table of Contents
