Setting Infeed Table Positive Stops - Grizzly G0958 Owner's Manual

Elevation Shaft
Setting Infeed Table
Positive Stops
The infeed tables on the Model G0958/G0959
include positive stops that can be adjusted to
allow the operator to quickly adjust table height
between cuts.
We recommend setting the minimum depth of cut
to ⁄ ", and the maximum depth of cut to
1
32
most operations.
Do not exceed ⁄ " cut per pass on this
1
16
machine or the risk of kickback and serious
injury will be greatly increased!
Each positive stop controls the top or bottom
range of movement for the infeed table. The jam
nuts on the G0958 (see Figure 55) and the set
screws on the G0959 (see Figure 56) lock the
stops in position so they will not move during
operations.
Tools Needed
Hex Wrench 3mm (G0959 Only) ....................... 1
Open-End Wrench 10mm (G0958 Only) ........... 1
Model G0958/G0959 (Mfd. Since 05/22)
Infeed Table
Adjustment Shaft
Jam
Nuts
⁄ " for
1
16
Figure 55. Location of infeed table positive stops
Qty
Figure 56. Location of infeed table positive stops
Hex
Nuts
(G0958).
Infeed Table
Lock Collars Adjustment Shaft
Set Screws (2 of 4)
(G0959).
-51-