Activate Diagnostic Messages Via Step 7 - Siemens SINAMICS G120 Original Instructions Manual

Sinamics g120 inverter with cu230p-2 control units

Hide thumbs Also See for SINAMICS G120:

Table of Contents

Activate diagnostic messages via STEP 7

Proceed as follows to activate the diagnostic messages of the inverter:

1. In HW Config, select the inverter.

2. By double clicking on slot 0 in the station window, open the property window for the

3. Select the Parameters tab.

4. Activate the standard alarms.

You have activated the diagnosis messages.

With the next ramp-up of the controller, the diagnostic messages of the inverter are then

transferred to the controller.

Inverter with CU230P-2 Control Units

Operating Instructions, 11/2013, FW V4.6.6, A5E02430659B AG

Highlight inverter in HW Config

inverter's network settings.

A.7 Application examples

Sinamics g120d Cu230p-2