Activate Settings - Siemens Sinamics G120 Function Manual

Commissioning
5.10 Configuring safety functions and PROFIsafe with Startdrive
Parameter
p9501.30
p10050
Settings for the discrepancy time and the signal filter of the fail-safe digital inputs:
5.10.3

Activate settings

Loading the settings into the drive
Procedure
Proceed as follows to activate the safety functions settings in the drive:
1. Save the project.
2. Select "Load to device".
3. Connect Startdrive online with the drive.
4. Press the "Start safety commissioning" button.
5. Enter the password for the safety functions.
If the password is the factory default, you are prompted to change the password.
If you try to set a password that is not permissible, the old password will not be changed.
124
Description
Enable F-DI in PROFIsafe telegram(Factory setting: 0 bin)
0 signal: F-DI is inhibited in the PROFIsafe telegram
1 signal: F-DI is enabled in PROFIsafe telegram
Transfer PROFIsafe F-DI (Factory setting: 0000 bin)
Bit 0 0 signal: No transfer
1 signal: PROFIsafe status word 5 transfers the status of F-DI 0
Bit 1 0 signal: No transfer
1 signal: PROFIsafe status word 5 transfers the status of F-DI 1
Bit 2 0 signal: No transfer
1 signal: PROFIsafe status word 5 transfers the status of F-DI 2
Setting the filter for fail-safe digital inputs (Page 157)
Safety Integrated - SINAMICS G110M, G120, G120C, G120D and SIMATIC ET 200pro FC-2
Function Manual, 01/2017, FW V4.7 SP6, A5E34261271B AD