Create Generic I/O Module - Siemens SINAMICS G120 Original Instructions Manual
Sinamics g120 inverter with cu230p-2 control
units
Hide thumbs
Also See for SINAMICS G120:
- List manual (1256 pages) ,
- Manual (732 pages) ,
- Operating instructions manual (550 pages)
Table of Contents
Advertisement
7.5.6
Create generic I/O module
For certain control systems, you cannot use the EDS file provided by the ODVA. In these
cases, you must create a generic I/O module in the control system for the cyclic
communication.
Procedure
Proceed as follows to create a generic I/O module:
1. In your control system, via "New module" create a new "I/O module", "Generic" type.
2. In the control system, enter the lengths for the process data for cyclic communication,
3. In STARTER, set the same values for IP address, Subnet Mask, Default Gateway and the
You have created a generic I/O module for cyclic communication with the inverter.
Inverter with CU230P-2 Control Units
Operating Instructions, 11/2013, FW V4.6.6, A5E02430659B AG
which you have selected in STARTER, r2067[0] (input), r2067[1] (output), for example:
Standard telegram 2/2.
Name of Station as in the control system (see Communication settings for Ethernet/IP
(Page 138))
Configuring the fieldbus
7.5 Communication via EtherNet/IP
147
Advertisement
Table of Contents
