Mounting The Servo; Safety Precautions; Mounting The Power Switch - FUTABA 10J Instruction Manual

MOUNTING THE SERVO

Wood screw
Rubber
grommet
Brass eyelet
Servo mount
(Airplane/Glider)
To prevent the servo lead cable from being
little slack in the cable and fasten it at suitable
points. Periodically check the cable during daily
maintenance.
Margin in the lead wire.
Fasten about 5-10cm
from the servo outlet so
that the lead wire is neat.
MOUNTING THE POWER
SWITCH
make a rectangular hole that is a little larger than
the total stroke of the switch so that you can turn
the switch ON/OFF without binding.
Avoid mounting the switch where it can be
recommended to mount the power switch on the
2.3-2.6mm nut
washer
Rubber
grommet
Brass eyelet
Servo mount
2.3-2.6mm screw
(Helicopter)

SAFETY PRECAUTIONS

you install receiver and servos
*Cutting or binding the receiver's antenna will
and may cause a crash.
on the gear train and/or power consumption
causing rapid battery drain.
vibration will travel to and possibly damage the
servo.
when
31