FUTABA 10J Instruction Manual page 116

SNAP ROLL
Function
This function performs snap roll by switch (SwH).
NOTE： The trainer function cannot be turned on simultaneously with this
function. If the trainer function is active, trainer ACT
screen. After setting the trainer function to INH , turn on this function.
Method
Calling the setting screen
① Call the menu screen from the
home screen by pressing the +
key for 1 second.
＋
Activating the function
● Select the setting item with
the Jog key.
Snap roll
■ Activating the function
① Select the "MIX" item and
then select the "OFF" by
pressing the + key or ‒ key.
＋
or
● W h e n y o u d o n o t u s e a
function, set to the "INH"
side.
■ Safe mode set
④ Select the "SAFE-MODE"
item and then select the
mode by pressing the +
key or ‒ key.
Range：
FREE, CH5+, CH5-
Default：FREE
116
Snap roll
② Select
（1 second）
Rate set
■ D i r e c t i o n s w i t c h
selection
② Select the "DIRC-SW1"
and "DIRC-SW2" item
and select each switch
−
by pressing the + key or
‒ key.
NULL, SwA ∼ SwH
● When a 3 position switch was selected at DIRC-SW1 setting, 1:R/U, 2:L/
U, 3:R/D switching is possible with 1 switch. At this time, DIRC-SW2
cannot be selected.
Safe mode setting can set the direction of the landing gear switch.
● When CH5- was selected, the safety device sets the landing gear switch to the
rear position and the snap switch is not effective even if operated. When the
landing gear switch is in the forward position, operation is possible. When CH5+
was selected, the safety device operates and the snap switch is ineffective even
if operated. When the landing gear switch is in the rear position, operation is
possible.
● When FREE was selected: The safety device does not operate regardless of the
switch direction.
is displayed on the
"SNAP ROLL"
from the menu with the
Jog key.
Range：
Default：NULL
(ACROBATIC)
（Direction Switch）
1: R/U
2: L/U
3: R/D
4: L/D
③ Open the setting screen by
pressing the Jog key.
（Snap roll direction）
● W h e n I N H i s s e l e c t e d , t h e
function cannot be used. To use
the function, select OFF(ON).
Safe mode set
Direction Switch selection
■ Servo Rate set
③ Switch the DIRC-SW1 or DIRC-
SW2 in the direction you are
wanting to adjust by pressing
the + key or ‒ key at the AIL ,
ELE , and RUD items.
Range：-120 ∼ +120%
● Set the R/U, L/U, R/D, and L/D
directions.
SW1 SW2