Motor Switch - FUTABA 10J Instruction Manual

MOTOR SW
Function
This function sets the operating motor when
the EP glider with motor is started by switch. The
operating speed can individually set in 2 ranges
of high from slow and slow from high. If you do
motor control with a throttle stick, you should
set this function to INH.
Method
Calling the setting screen
① Call the menu screen from the
home screen by pressing the +
key for 1 second.
＋
● Select the setting
i t e m w i t h t h e
Jog key.
Motor
■ Activating the function
① Select the "MODE" item
a n d t h e n s e l e c t t h e
"OFF" by pressing the
+ key or ‒ key.
● When you do not use a function, set to the
"INH" side.
■ Switch direction
③ S e l e c t t h e
" D O W N " it em
and then select
the position by
pressing the + key or ‒ key.
● 2P SW： UP, DOWN
● 3P SW： UP, UP&D, UP&C, CNTR,
C&DN, DOWN
DANGER
Always remove the propeller from the motor during setting and at operation checks.
156

Motor switch

② Select
（1 second）
● Decelerating speed setting
＋
or
＋ −
or
WING TYPE 1AIL 2AIL 2AIL+1F 2AIL+2F 2AIL+4F
"MOTOR SW"
from the menu with the
Jog key.
● Accelerating speed setting
■ Switch selection
② Change the switch by
−
pressing the + key or
‒ key a t t h e s w i t c h
selection item.
Range：SwA ∼ SwH
■ Speed setting
④ Select "SPEED " next to (OFF) and (ON) by Jog key.
Range：OFF,1 ∼ 10(more slowly)
(ON) is the acceleration speed setting.
●
(OFF)
is the deceleration speed setting.
●
(GLIDER)
③ Open the setting screen by
pressing the Jog key.
● Present motor control position
● If this safety switch is not ON, the
motor will not start even if the
starter switch is turned on. In
"NULL", a safe function does not
work.
● Start SW
● A setup of the motor control
position (3CH end point)of High-
side and Low-side
＋ −
or