Charging The Batteries - FUTABA 10J Instruction Manual

CHARGING THE BATTERIES

1. Connect the transmitter charging jack and batteries to the transmitter and receiver connectors
of the charger.
2. Plug the charger into a wall socket.
3. Check that the charger LED lights.
Receiver battery
Below you will find some general rules and guidelines which should be adhered to when
charging transmitter and/or receiver battery packs. These are included to serve only as general
• Do not allow children to charge battery packs without adult supervision.
• Do not charge battery packs that have been damaged in any way. We strongly suggest frequent
inspection of the battery packs to ensure that no damage has occurred.
•
immediately and allow to cool.
•
• Do not deep cycle NiMH batteries as permanent damage could result.
•
•
•
• NiMH cells have a self-discharge rate of approximately 20-25% (compared to 15% for NiCd
• Never connect the battery in reverse. Reverse connection will cause the battery to overheat or
will damage the inside of the charger.
• Do not add an additional charge after charging.
•
•
• Do not connect two battery packs or more to one output terminal.
• Avoid extremely cold and hot places and the direct sunlight when you charge batteries.
•
cause abnormal charging and overheat.
22
(When the rechargeable battery option is used)
Charger
TX: Transmitter charging indicator
RX: Receiver charging indicator
To transmitter charging jack
According to the description of the battery to be used
out full charge.
use of a fast charger may damage the batteries by
overheating and dramatically reduce their lifetime.
recommended.
remove the battery from the system to charge it.
Charger for this battery is recommended to use LBC-
4E5.
Note that the