FUTABA 10J Instruction Manual page 54

P.MIX Selection
■ Calling the setting screen
① Use the Jog key to select the P.MIX
number you want to use.
② Call the setting screen by pressing
the Jog key.
● P.MIX1 ∼ 4（normal type）
● P.MIX5 ∼ 6（curve type）
Mixing rate adjustment
Master CH selection
Slave CH selection
● Select the item with the
Jog key.
P.MIX1 ∼ 4
■ Function activation
① Select the MIX item and select ON
or OFF by pressing the + key or ‒
key.
＋
or
● When you do not want to use
the function select INH.
■ Mixing rate adjustment
④ Select the RATE item and adjust the
mixing rate by pressing the + key or ‒
key for each direction of the stick, etc.
selected at the master channel.
（Changing the ON/OFF Switch）
■ ON/OFF Switch selection
① Select the "SW" item and then
select the switch by pressing the +
key or ‒ key.
＋
or
Selection range：SwA ∼
SwH、THR
54
（P.MIX1 ∼ 4 set up screen）
Offset
■ Master/slave channel selection
② Select the MASTR channel you want
to use by pressing the + key or ‒ key.
③ Select the Slave channel you want to
−
us by pressing the + key or ‒ key.
● A knob VR or digital trim DT5/DT6, as well as channels 1
to 10, can be specified as the master channel. In addition,
when OFS was selected as the master channel, slave servo
operation is offset.
＋
■ Switch ON direction setting
② Select the "POSI" item and select the switch
ON direction by pressing the + key or ‒
key.
−
● 2P SW：NULL （ always ON） , UP, DOWN
● 3P SW：NULL （ always ON） , UP, UP&D, UP&C, CNTR, C&DN,
DOWN
● THR stick: Hold the stick at the ON/OFF point
and set the ON/OFF position by pressing the Jog
key for 1 second. (If the Jog key is pressed for 1
second when the position was set, it returns to
the NULL state.) The switch ON direction can also
be selected by pressing the + key or ‒ key.
（P.MIX 1-6）
（Master CH Current position）
Range：-100 ∼ +100%
−
or
● When you want to return the set value
to the initial value, press the + key and ‒
key simultaneously.
to P.MIX1 ∼ 4
set up screen
to P.MIX5 ∼ 6
set up screen
Function activation
● When INH is selected, the
function cannot be used.
When ON or OFF is selected,
the function is activated. ON
and OFF changes are linked
to the switch.
Trim ON/OFF
Switch selection
Switch direction
＋ −
or
Default：0%
＋ −
or
（1 second）