Test Reporting Options; Reports; Zone Tamper Report; Walk Test Report - Bosch Solution 2000 Installation Manual

Control Panel
Notice!
If automatic Test Reports are not required, program the Hour/Minute/Repeat Interval in
Locations 428 to 431 and 434 as 0.
15.6

Test Reporting Options

Item
Test Reporting Options 0435
Location 435 is set by default to report only to Receiver 1.
15.7

Reports

15.7.1

Zone Tamper Report

A Zone Tamper Report (Contact ID Event Code 144) is sent when Option 14 is programmed in
Location 266 and the zone loop using split EOL resistors (3K3/6K8) with tamper (1K)
becomes open circuit.
15.7.2

Walk Test Report

A Walk Test Report (Contact ID Event Code 607) is sent when either the Installer or Master
Code holder activates Walk Test Mode.
15.7.3

Bypass Report

A zone is bypassed when it is manually isolated. A Zone Bypass Report (Contact ID Event Code
573) is sent at the end of Exit Time for any zone that was manually isolated. A 24-Hour Zone
sends a Zone Bypass Report when the zone is selected to be isolated.
A Zone Bypass Restore Report is sent when the system is disarmed. All bypassed zones are
automatically cleared when the system is disarmed.
Notice!
A 24-Hour Fire Zone that is manually bypassed reports as Contact ID Event Code 571.
Other 24-Hour Zone that is manually bypassed reports as Contact ID Event Code 572.
15.7.4

Trouble Report

A zone is in trouble when it is unsealed at the end of Exit Time. A Sensor Trouble Report
(Contact ID Event Code 380) is sent to indicate that one or more zones were automatically
isolated by the system.
A Sensor Trouble Restore Report is sent for Burglary Zones when the zone is resealed or the
next time the system is disarmed (whichever happens first). A 24- Hour Zone sends a restore
signal only when it is resealed.
A 24-Hour Panic Zone Trouble is reported as Contact ID Event Code 375.
Bosch Security Systems, Inc.
Location Option
0 = No report required
1 = Report to Receiver 1
2 = Report to Receiver 2
3 = Report to Receiver 3
4 = Report to Receiver 4
5 = Report to Receiver 1,2,3,4
6 = Report to Receiver 1 (2,3,4 backup)
7 = Report to Receiver 1 (2 backup) and
Receiver 3 (4 backup)
Installation Guide
System Reporting Information | en
Default New
1
2017.10 | 03 | F.01U.298.026
113