Bosch Solution 2000 Quick Start Manual

Touchscreen - Solution 2000/3000
Troubleshooting (Installers)
1
Problem
• Install the
TouchOne
2
Problem
• Mounting the
TouchOne on
the Wall
3
Problem
• Remove the
TouchOne
from the
Wall Mount
4
Problem
• Bluetooth not pairing
1
Solution
• Tools needed:
• Phillips head screw driver
• Wire cutter/stripper
• 5mm cable
- 12V DC 1500mA Power Adapter (we recommend 12VDC/1.5A Battery
backed up PSU)
• Please ensure that the TouchOne is receiving a minimum of 10.5V, voltage levels
below this may result in the TouchOne shutting down during power intense tasks.
Classic Panel: Solution
2000/3000 Panel:
2
Solution
• To mount the Generation 1 TouchOne simply apply equal
pressure across the touch screen until you feel it clip into
place. Check that all the sides are in place.
• To mount the Generation 2 and Mini TouchOne slide to
the right hand side as per the image.
3
Solution
• To remove the Generation 1 TouchOne from the Wall
Mount, you will need to use a small screwdriver and
insert it into the small cut outs on the right-hand side to
the camera. This will lift the touchscreen away from the
mount. Slowly insert the screwdriver around the edges to
lift them away. This will eventually lift the TouchOne out
of the Wall Mount.
• The Generation 2 and Mini TouchOne are removed
by pressing the clip that is located on the back at the
opposite side of the camera. Using a finger or small
screwdriver, push the clip towards you and slide the
TouchOne in the direction of the camera.
4
Solution
• To pair a smart phone with your TouchOne ensure that
Bluetooth is turned on on your mobile device, then press the
Settings button from the home screen.
• Press the Users button, then enter the requested master pin,
you should now see a list of users.
• Select the user you wish to pair the mobile device with. You
will now see a button Add Bluetooth Device.
• If this does not work, follow wifi update process step 12.
The 7 inch TouchOne can be mounted in two
orientations, either portrait or landscape.
The TouchOne mini must be mounted in
landscape orientation.
Gen 2 / Mini
Gen 2 / Mini