How To Read The Codeplug - Motorola MCS 2000 User Manual

How to Read the
Codeplug
Reading Codeplug Data from
the Radio
Reading Disk Codeplug Files
Follow the procedure below to read the codeplug:
1. Start up the RSS. If you are not already at the MAIN MENU, press
any key at the BANNER screen to access the MAIN MENU.
2. From the MAIN MENU, press F3; the GET/SAVE/PROGRAM MENU
will be displayed.
You may read the codeplug from the radio or from the archive disk.
Turn on the radio and press F2. A series of status messages will appear
in the upper right corner of the screen. The read process will take
approximately one minute, but may vary depending on the processing
power of your computer. After the codeplug is read, the GET/SAVE/
PROGRAM MENU will be displayed.
Note: If a communication error occurs, a pop-up window will be
displayed. If no errors occur, the center of the screen will display
the progress of the codeplug read activity.
Press F3 at the GET/SAVE/PROGRAM MENU. The ARCHIVE FILE
screen will be displayed. An archive path and the list of files in that
path will be displayed. By default, the archive path will be the
corresponding path specified on the CONFIGURE PATHS AND PORT
screen. If you want to retrieve a file from another path, press F2, type
in the path name and press Enter. The names of the files in the new
path will be displayed.
1. Use the Enter, Tab, Shift or arrow keys to highlight a desired file
name.
2. To retrieve the highlighted file, press F8. The selected file will be
retrieved, validated and placed in computer memory. The progress
of the read process will be displayed on the screen.
21