Motorola MCS 2000 User Manual page 228

Field Definitions
Personality
Repeater Access
Tone Signalling System
Access Type
RAB 1 Code Type
RAB 1 Singletone (Hz)/RAB 1
MDC Repeater ID/RAB 1 DTMF
Code
222
Use the UP/DOWN arrow keys, enter the system number directly, or
use the F3/F4 function keys to select the desired Conventional
Personality.
Note: Refer to the Motorola Radio Catalog Sheets for the
maximum number of personalities allowed for this model.
This option enables Repeater Access on this personality. Repeater
Access is used to access a repeater. Typically, upon receiving the
Repeater Access code word the repeater will remain in repeat mode
until the hangtime expires.
Repeater Access can be one of the following:
Manual The Repeater Access code word will be sent when the side
button designated for Repeater Access is pressed; up to two side
buttons can be designated for Repeater Access. The Repeater
Access code word will also be sent automatically in prior to
user-initiated data transmissions (that is, prior to Emergency,
Status, or Message transmission).
Automatic The Repeater Access code word will be sent preceding every
user-initiated transmission. Repeater Access can be sent either as
MDC Repeater Access code words or as a Single Tone
transmission. The type of Repeater Access Selected will
determine which Repeater Access list is available.
This field will be visible only if the Repeater Access field is set to Enabled.
Use the UP/DOWN arrow keys to select the Tone Signalling System to
be used by this personality.
The default is 1.
This field will be visible only if the Repeater Access field is set to Enabled.
Use the UP/DOWN arrow keys to select the Repeater Access Type.
Choices are Manual or Auto.
The default is Manual.
This field will be visible only if the Repeater Access field is set to Enabled and
the Access Type field is set to Manual. Use the UP/DOWN arrow keys to
select the type of Repeater Access Button operation. Depending on your
radio capabilities, choices will be Single Tone, DTMF or MDC.
The default is Single Tone.
This field will be visible only if the Repeater Access field is set to Enabled and
the Access Type field is set to Manual. For Single Tone and MDC, enter
the index from the Single Tone List or the MDC Repeater ID List. For
DTMF, enter the tone value; DTMF Tone values are 0 (zero) through 9,
"*" and "#". Alternatively, the UP/DOWN arrow keys could be used to
scroll through indexes/values.
The default is 300 Hz for Single Tone, 0 (zero) Hz for DTMF, and 1 Hz
for MDC.