Motorola MCS 2000 User Manual page 210

F8 - PHONE OPTIONS
F9 - MORE OPTIONS
Field Definitions
Personality
Receive Only
Direct/Talkaround
Time-Out Timer (sec)
204
This function will be active only when the Phone Operation field has been
set to a value other than None. Allows access to Conventional
interconnect access codes and digit timing parameters for this
personality.
Allows you to access additional parameters that can be used to
customize a radio to specific system requirements.
Use the UP/DOWN arrow keys to select the desired Conventional
Personality. You may also enter the number directly.
Note: Refer to the Motorola Radio Catalog Sheets for the
maximum number of personalities allowed for this model.
Use the UP/DOWN arrow keys to enable/disable Receive-only
operation on this personality. If this feature is enabled, all
transmissions including signalling are inhibited.
The default is Disabled.
This field will not be visible if the Receive Only field is set to Enabled. Use
the UP/DOWN arrow keys to enable Talkaround operation on the
current personality. In Talkaround (or Direct) mode, the radio will
transmit on the receive frequency. This is useful when a repeater is not
in operation or is out of range.
Talkaround may be used in a manual or automatic mode. In the
manual mode, a talkaround switch must be defined on the RADIO
WIDE BUTTON SWITCH MENU (F4/F3/F3). The switch may be either
on the top or side of the radio or on the keypad menu (if applicable).
Note: If talkaround operation is enabled and no button/switch
is assigned, the radio will default to talkaround operation on
this personality.
The default is Enabled.
This field will not be visible if the Receive Only field is set to Enabled. Use
the UP/DOWN arrow keys to select the Time-Out Timer (TOT) for this
personality. Time-Out Timer determines the amount of time the radio
can continuously transmit before it must be de-keyed. When the Time-
Out Timer is about to expire, the radio beeps and then stops
transmitting.
Each personality may have one of four different TOT values. These
values are: 15, 30, 45, 60, 90, 120 and 180 seconds and Infinite (that
is, Time-Out Timer disabled). The four values for the radio can be
changed on the RADIO WIDE OPTIONS MENU (F4/F3/F2/F9).
The default is 60 seconds.