Exit the RSS
36
Note: You will receive an error message if cloning cannot be
performed for any reason. Check all connections or refer to
Appendix A for error codes and their explanations.
9. Once cloning is completed, make sure you are at the GET/SAVE/
PROGRAM MENU or MAIN MENU and then disconnect the radio.
When programming or tuning a radio DO NOT
disconnect the radio from the RIB when the computer
!
is communicating with the radio. This action may leave
the radio in an inoperable state. Disconnect the radio
Caution
only when you are in the MAIN MENU or GET/SAVE
screens.
Repeat steps 6 through 10 to clone additional radios as necessary.
Note: The IDs for MDC-1200, DTMF, etc. must be changed manually
if you want to have unique IDs. You may do this from
CHANGE/VIEW sub-menus immediately after cloning each
radio.
Press Esc to back up to the MAIN MENU. At the MAIN MENU, press
F10 and then F2 to exit to DOS.