Motorola MCS 2000 User Manual page 219

Call Alert Encode
Selective Call Decode
Unmute Type
Selective Call Decode
Auto Sel Call Transmit
Use the UP/DOWN arrow keys to enable/disable Call Alert Encode. If
this feature is enabled, the user will be able to send pages to other
radios.
Note: If this feature is enabled and the user must be able to select
target radio(s) ID(s) via the Call list, data must be programmed into
the appropriate Call List Table.
The default is Disabled.
Use the UP/DOWN arrow keys to enable/disable the MDC Selective
Call Decode feature for this personality. If this feature is enabled, this
feature allows the user to receive individual and group calls. It is
intended not so much to ensure privacy but to eliminate annoyance
to users when they receive traffic that does not pertain to them.
The default is Disabled.
This field will be visible only if the Select Call decode field is set to Enabled.
Use the UP/DOWN arrow keys to select the muting type from among
the following:
And Muting Radio must receive both the Selective Call code (or Quik-
Call II tones) and the proper code (PL/DPL and/or
SECURE) before it will unmute.
Or Muting Radio will unmute on proper code (PL/DPL and/or
SECURE) or on carrier after the Selective Call code (or
Quik-Call II tone) is decoded.
The radio will mute or become call-squelched again when the radio is
reset by the manual reset option or by the expiration of the auto reset
timer.
The default is Or.
Use the UP/DOWN arrow keys to enable the MDC Selective Call
Encode feature for this personality. If this feature is enabled, it allows
the user to send calls to an individual radio or to a group of radios. It
is intended not to ensure privacy but rather to eliminate annoyance to
users when they receive traffic that does not pertain to them.
Note: If this feature is enabled and the user must be able to select
target radio(s) ID(s) via the Call list, data must be programmed into
the appropriate Call List Table
The default is Disabled.
This field will be visible only if the Selective Call Decode field is set to
Enabled. Use the UP/DOWN arrow keys to enable/disable the Auto
Selective Call Transmit option. If this option is enabled, the radio will
remain in Selective Call mode after the PTT switch is released. If not,
it will exit Selective Call mode as soon as the PTT switch is released.
The default is Enabled.
213