Motorola MCS 2000 User Manual page 156

Affiliation Type (Type II/IIi Only)
Dynamic Regrouping
Zone
Chan
Remote Monitor
RM Base Time
OmniLink
150
Use the UP/DOWN arrow keys to select the desired Affiliation Type.
Automatic The radio will immediately affiliate with the central controller as
soon as it is turned on and will automatically re-affiliate each
time the talkgroup is changed (that is, if the selected talkgroup
does not match last affiliated talkgroup).
On PTT The radio will affiliate only when PTT is pressed.
SmartZone radios MUST use Automatic Affiliation. These radios always
affiliate on power-up and on site switches (in addition to affiliating on
Talkgroup changes).
The default is On PTT.
Use the UP/DOWN arrow keys to enable/disable this feature for the
current system. A Dynamic Regrouping Talkgroup position (DYN)
must be assigned on the ZONE/CHANNEL ASSIGNMENT screen (F4/
F8). Enabling Dynamic Regrouping will automatically add DYN to the
list of talkgroups on that screen. Dynamic Regrouping allows the
dispatcher to temporarily reassign selected radios operating in separate
fleets and/or talkgroups into a single group. The default is Disabled.
Note: Only one DYN position may be assigned for each system.
This field will be visible only if Dynamic Regrouping is enabled. Use the UP/
DOWN arrow keys to make your selection or enter a number directly.
This is the zone position used when a radio is dynamically regrouped.
This is used in conjunction with the channel position to determine
which zone/channel talkgroup will be used during Dynamic
Regrouping.
This field will be visible only if Dynamic Regrouping is enabled. Use the UP/
DOWN arrow keys to make your selection or enter a number directly.
This is the channel position used when a radio is dynamically
regrouped. This is used in conjunction with the zone position to
determine which zone/channel talkgroup will be used during
Dynamic Regrouping.
Use the UP/DOWN arrow keys to enable/disable Radio Trace (remote
monitor) for this system.
The default is Disabled.
This field will be visible only if Remote Monitor is enabled. Use the UP/
DOWN arrow keys to select the base time in seconds or enter a value
directly. The radio will transmit during a Radio Trace for this system.
Valid options are 15, 30, 45 and 60 seconds.
The default is 15 seconds.
This field will be visible only if the Coverage Type is SmartZone. When an
OmniLink feature is enabled, the radio will be allowed to roam from
one SmartZone System within an OmniLink System to another
SmartZone System within the same OmniLink System.
The factory default is Disabled.