Channel Assignment Data (Uhf/Vhf Models Only) - Motorola MCS 2000 User Manual

Channel
Assignment Data
(UHF/VHF models
only)
DDCF
Function Key Descriptions
F3 - PREV SYSTEM
F4 - NEXT SYSTEM
F6 - CHAN ASSIGN (for UHF/
VHF) or CONTROL CHANNEL
MENU (for 800/900 MHz)
From the MAIN MENU, press F4 twice, F3 and then F6 to access this
screen.
MOTOROLA Radio Service Software
MCS Model:
...TRUNKING:SYSTEM:CHAN ASSIGN
System............ 1
Rx Channel Ranges - MHz
------------------------------
Spacing
# Status (kHz) Start
- ------ ------- -----
1 Enable 6.25 136.00000
2 Blank
3 Blank
F1 F2 F3
HELP PREV NEXT
SYS SYS
This screen is used to enter the Channel Assignment Data used for
Other Band Trunking or OBT. Three different frequency splits may be
defined for each system. After the receive and transmit ranges are
defined, press F6 to enter Control Channel frequencies.
Note: This information must match the Central Controller exactly or
the system will not work.
Press Tab to select the desired field, or press the desired function key
(F1 - F10). If a field is highlighted, use the UP/DOWN arrow keys to
select the desired choice or value.
Accesses the previous system.
Accesses the next system.
A system key or FTR key is required to access this field. Brings up a screen
where you can enter the control channels for, or assign channels to,
the system.
Enter or Scroll to Select System.
CHANNEL ASSIGNMENT DATA
-----------------------
Tx Channel Ranges - MHz
----------------------------------
Spacing
End Status (kHz)
--- ------ -------
136.00000 Enable 6.25
Blank
Blank
F4 F5 F6 F7
CONTROL
CHANNEL
Start End
----- ---
136.00000 136.00000
F8 F9 F10
EXIT
153