Siemens Sinamics s120 Commissioning Manual page 112
With starter
Hide thumbs
Also See for Sinamics s120:
- Function manual (1094 pages) ,
- Diagnostic manual (947 pages) ,
- Manual (848 pages)
Table of Contents
Advertisement
Commissioning
3.3 STARTER commissioning tool
7. Select the drive unit and call the shortcut menu "Target device > Online access ...".
8. Click the "Module addresses" tab.
The IP address that you set must be located under "Connect to target station".
Image 3-23
Assigning an IP address and a name to the drive unit
With the STARTER commissioning tool, you can assign an IP address and a name to the
PROFINET interface (e.g. CBE20) of the drive unit. The following steps are required:
1. Connect the PG/PC via a Crosslink-Ethernet cable with the CBE20, inserted in the
CU320-2.
2. Switch on the Control Unit.
3. Open the STARTER commissioning tool.
4. Call the menu "Project > Accessible nodes" or click the symbol
– The search is performed for available nodes connected to PROFINET.
– The Control Unit is identified and displayed under "Accessible nodes" as the bus node
112
Setting online access
with the IP address 0.0.0.0, without any type information.
Image 3-24
Bus nodes found
STARTER Commissioning Manual
Commissioning Manual, (IH1), 07/2016, 6SL3097-4AF00-0BP5
"Accessible nodes".
Advertisement
Table of Contents
