SET1200000
12 Installing M.2 Flash Device
36
- This chapter describes the procedure for installing M.2 Flash Device.
SET1201000
12.1 Conditions for installing components
- Can be installed on BMM Board installed in SB#0.
- The order of installation is from M.2#0
SET1201010
12.1.1 Firmware version
- No conditions.
SET1201020
12.1.2 Maximum installation amount
- 2 units.
SET1201030
12.1.3 Conditions concerning combined use of M2.Flash Device
- No conditions.
SET1201040
12.1.4 Base Unit state
- AC power to the Base Unit is off.
79