Preparations; Outline; Scope; Typical Time Required For Assembling Options - Cisco C880 M5 Service Manual

SET0100000

1 Preparations

This chapter provides an overview, including the addition procedure and addition preparations.
ANNT)
If the work procedure for upgrading starts with AC power off status, set power restoration policy
setting "Restore to powered state prior to power loss" or "Always off" before AC power off.
Make sure the setting with the system administrator and modify it if necessary.
Set the default setting after completing the work procedure for upgrading.
See Appendix E.9
SET0101000

1.1 Outline

This chapter provides an overview, including the installation procedure and installation preparations.
SET0101010

1.1.1 Scope

This section describes the scope of the addition instructions, typical time required for assembling
options, work assignment, and notes.
SET0101020

1.1.2 Typical time required for assembling options

The following table lists the typical time required for assembling options.
Option
System board
CPU
Memory
PCI card
I/O unit B (IOUB)
Disk unit for SAS (DU_SAS)
Disk unit for PCIe SFF (DU_PCIE)
Internal hard disk drive (HDD)
Internal solid state drive (SSD)
Internal PCIe SSD SFF
Power Supply Unit (PSU)
M.2 Flash Device
eLCM Activation License
TPM
"Power Restore Policy
Table 1.1.2 Typical time required for assembling options
setting" for more information.
Option work time (minute)
46 / unit
20 / set
31 / set
36 / card
36 / unit
46 / unit
46 / unit
31 / drive
31 / drive
27 / unit
36 / unit
36 / unit
36 / unit
12