SET0400000
4 Installing Memory
31
This chapter describes the procedure for installing memory.
In this chapter, SB represents a System Board.
SET0401000
4.1 Conditions for installing components
By installing the memory, confirm to the system administrator whether it is necessary to change the
"Memory Operation Mode" setting.
SET0401010
4.1.1 Firmware version
- No conditions.
SET0401020
4.1.2 Number of mounted DIMMs
The system configuration and the setting are confirmed to the system administrator.
(See "Table 4.1.2".)
Normal Mode
1 set per addition
set: same 2 DIMMs.
SET0401030
4.1.3 Conditions on mixing different types of DIMM
- When mixing DIMMs with different capacities within system, follow the specification in
"Figure 4.1.3-1".
- Confirm the status (capacity, rank and mounting locations) of the DIMMs currently installed on the
SB. See Appendix E.7
Table4.1.2
Memory Operation Mode
Full Mirror Mode
2 sets per addition
"Checking memory
type".
Address Range
Mirror Mode
2 sets per addition
29
Spare Mode
1 set per addition