Table of Contents
Advertisement
SET0503030
5.3.3 Installing PCI card (Other than slot#2 and slot#3)
Install according to the following procedures.
ANNT)
- The installation location and quantity have to indicate by the system administrator.
- Confirm connecting position of power cable of the Base Unit beforehand.
(1) Turn off AC power of the Base Unit.
(2) Remove the IOUB out of the Base Unit.
See Appendix F.3.2
(3) Install the PCI card into the IOUB.
See Appendix F.9.1
Refer to Appendix F.16
Slot#0, and FBU (BBU) is added.
(4) Install the IOUB into the Base Unit.
See Appendix F.3.1
(5) Turn on AC power of the Base Unit.
→ Wait until green indicator of the "System Power" turns off.
(6) Make sure that the Alarm indicator of the IOUB is not lit. (See "Figure 5.3.3".)
(7) Install SPF+module if you have one.
See Appendix F.13
(8) Proceed to
"Removing
IOUB".
Installing PCI card (other than slot#2 and
"FBU for Ext. SAS RAID
"Installing
IOUB".
"Installing LAN card
"5.4 Verifying
operation".
slot#3)".
Card" When "SAS RAID Card" is installed in
Figure 5.3.3
module".
42
Advertisement
Table of Contents
