Installing Option (Slot#2 Or Slot#3) - Cisco C880 M5 Service Manual

SET0503020

5.3.2 Installing option (Slot#2 or Slot#3)

Install according to the following procedures.
ANNT)
- The installation location and quantity have to indicate by the system administrator.
(1) Proceed to the net procedure according to the following procedures.
→ When the Base Unit state is "AC Power On, System Power On". Proceed to procedure (2).
→ When the Base Unit state is "AC Power On, System Power Off" or "AC Power Off".
Proceed to procedure (3).
(2) The system administrator makes the PCI card installable state.
(3) Remove the PCI cassette of installation slot.
See Appendix F.9.4
(4) Mount the PCI card in PCI cassette.
See Appendix F.9.3
(5) Install the PCI cassette into the IOUB.
→ Wait about 10 seconds
(6) When the Base Unit state is "AC Power Off", turn on AC power then wait about a minute.
(7) Make sure that the Alarm indicator of the PCI cassette is not lit. (See "Figure 5.3.2".)
(8) Install SPF+module if you have one.
See Appendix F.13
(9) Proceed to the next procedure according to the following procedures.
→ When the Base Unit state is "AC Power On, System Power On".
Proceed to
→ When the Base Unit state is "AC Power On, System Power Off".
Proceed to
"Removing PCI card (slot#2 and
"Installing PCI card (slot#2 and
"Installing LAN card
"5.5 Preparation of handing over to the system
"5.4 Verifying operation".
slot#3)".
slot#3)".
Figure 5.3.2
module".
administrator".
41