Table of Contents
Advertisement
SET0703030
7.3.3 Installing option (System Power Off)
Install according to the following procedures.
ANNT)
- The installation location and quantity have to indicate by the system administrator.
(1) Remove the dummy of HDD/SSD out of the DU_SAS.
(2) Install the HDD/SSD into the DU_SAS.
(3) Turn on AC power of the Base Unit when the Base Unit state is "AC Power Off".
→ Wait until green indicator of the "System Power" turns off.
(4) Proceed to
SET0704000
7.4 Verifying operation
Confirm the HDD/SSD according to the following procedures.
(1) Connect the operation terminal.
See Appendix E.1
(2) Log in to the iRMC S5 Web from the operation terminal.
See Appendix E.2.1 "Login".
(3) Start Video Redirection.
See Appendix E.3.1
(4) Set "BIOS Setup" at "Boot Device Selector".
See Appendix E.4
(5) Turn on the system power.
See Appendix E.5.1
→ Wait for a few minutes until "Figure 7.4-1" is displayed. (Max. 10 minutes)
"7.4 Verifying
operation".
"Operation terminal
"Video Redirection
"Boot Device Selector
"Power
On".
connection".
start".
setting".
53
Advertisement
Table of Contents
