Activate Zone-Address In Alarm Mode (H8/S8) - Panasonic EBL128 Operating Instructions Manual

Panasonic Eco Solutions Nordic AB
MEW01623
31.8
Action
"Access"
Scroll to menu H8.
"A"
Scroll to menu S8.
"A"
Write the zone and
address, e.g. "12-45"
"A"
"Return"
Write another zone and
address, e.g. "12-34".
"A"
Rev: -
Activate zone-address in alarm mode
(H8/S8)
One alarm point (zone-address), not a whole zone, can be manually
activated, i.e. be set in alarm mode.
NOTE! All outputs, standard and programmable, which would have
been activated by a real fire alarm from the same alarm point, will be
activated by this "manually activated" alarm as well.
Text in display
Maintenance
Acknowledge SERVICE signal
Activate zone/address in alarm mode
Select zone: 00
Select zone: 12
001 ZONE-ADDR 12-45 LAST ZONE 12
"Alarm text for 12-45"
Select zone: 00
Select zone: 12
001 ZONE-ADDR 12-45 LAST ZONE 12
"Alarm text for 12-45"
EBL128 Operating Instructions V2.0.x
ACCEPT? H8
ACCEPT? S1
ACCEPT? S8
address: 00
ACCEPT?
address: 45
ACCEPT?
No. 01
address: 00
ACCEPT?
address: 34
ACCEPT?
No. 01
133
Comments
According to chapter
"Access", see page 81.
Press "A" to accept /
activate the fire alarm.
Normal fire alarm
presentation in the
EBL128 / FBP display.
If more alarm points have
to be set in alarm status,
press "Return" to select
another zone - address and
continue as above.
Press "A" to accept / start
the fire alarm.
The LEDs "Alarms
queued" (L2) are
indicating that more than