Disconnect / Re-Connect Addressable Zone Interface Input - Panasonic EBL128 Operating Instructions Manual

Panasonic Eco Solutions Nordic AB
MEW01623
31.3
Action
"Access"
Scroll to menu H8.
"A"
Scroll to menu S3
"A"
Depending on if "0" or
"1" is chosen, one of
the following will be
shown:
E.g. "0"
"001"
"A"
"A"
"Return"
"Return"
"Return"
Rev: -
Disconnect / Re-connect addressable zone
interface input (H8/S3)
To avoid damage on the units and EBL128 during physical connection
/ disconnection of units, it is highly recommended to have the zone
interface input disconnected (disabled), i.e. voltage free (dead).
Text in display
Maintenance
Disconnect / Re-connect COM loop
Disconnect / Re-connect addressable zone
interface input
Disconnect (=0) or Re-connect (=1) addr.
zone interface input?
Disconnect addressable zone interface
input, technical address: 000
Re-connect addressable zone interface
input, technical address: 000
Input technical address 001 disconnected
Disconnect addressable zone interface
input, technical address: 000
Disconnect (=0) or Re-connect (=1) addr.
zone interface input?
Disconnect / Re-connect addressable zone
interface input
Maintenance
EBL128 Operating Instructions V2.0.x
ACCEPT? H8
ACCEPT? S1
ACCEPT? S3
1 ACCEPT?
ACCEPT?
ACCEPT?
ACCEPT?
1 ACCEPT?
ACCEPT? S3
ACCEPT? H8
128
Comments
According to chapter
"Access", see page 81.
Press "0" or "1" and
press "A" to accept.
Write the COM loop
address (001-255). Press
"A" to accept.
Do more disconnections
or press "Return".
Write "0" or "1" and
press "A" to accept or
press "Return" menu S3.
Scroll or press "Return"
to H8.
Scroll or press "Return".