Table of Contents
Advertisement
Panasonic Electric Works Nordic AB
MEW01297 Rev: 2
6
6.1
Technical Description External Presentation Unit 1728, ver. 1.4.x
SW mode & Address setting
Each Ext. Presentation unit can in system EBL512 run in SW mode
1728 - 1587 or SW mode 1728 – 1582, i.e. it can be used as two
different types of units. It shall also have a unique address on the
RS485 line connected to the 1587 or 1582 board in the EBL512 c.i.e.
See EBL512 Planning Instructions.
The SW mode 1728 – 1587 shall be used in system EBL128 and an
optional RS485 transceiver component 4552 is required on the main
board in the EBL128 c.i.e. It shall also have a unique address on the
RS485 line connected to the main board connector "J1". See EBL128
Planning Instructions.
The SW mode 1728 – 1587 shall be used in system EBL512 G3. It
shall also have a unique address on the RS485 line connected to the
main board connector "J4". See EBL512 G3 Planning Instructions.
SW mode setting
A brand new ext. Presentation unit has no SW mode. It is factory set
to "Not selected" (and is hereby not addressable).
powered it will automatically be ready for the "SW mode setting".
As an alternative, an ext. Presentation unit in operation
for the "SW mode setting" via the jumper "J4" in the unit. See the
following chapter.
When the ext. Presentation unit is ready for the "SW mode setting"
this is indicated by the LED "L2" (Alarms queued). The back-light is
turned on and the following information is shown in the display:
MODE SETTING!
Type xxxxxxxxxxxx
XXXXXXXXXXXX
can be changed to one of the following:
- 1735 – 1587
- 1736 – 1587
- 1826 – 1587 2
nd
Cab
- 1826 – 1582 2
nd
Cab
- 1826/28 – 1587
- 1826/28 – 1582
- 1728 – 1587
- 1728 – 1582 (Not for systems EBL128 & EBL512 G3.)
- Not selected
Scroll to the wanted SW mode with the push button "P1" (black).
Store the selected SW mode with the push button "P2" (yellow) and
the unit will automatically be ready for the "Address setting ", see
below.
7
Also when a unit not in operation but with the mode and address set before,
is powered.
Change = Black
Store = Yellow
12
When it is
7
can be ready
Advertisement
Table of Contents
