Alcatel-Lucent 7450 ESS-12 Configuration Manual page 469

ntp
Syntax ntp
Context show>system
Description
This command displays NTP protocol configuration and state.
Output Show NTP Output — The following table describes NTP output fields.
Enabled
Admin Status
NTP Server
Stratum
Oper Status
Auth Check
System Ref. ID
Auth Error
Auth Errors
Ignored
Auth key ID Errors
Auth Key Type
Errors
Reject
7450 ESS OS Basic System Configuration Guide
Label
yes
— NTP is disabled.
no
yes
— Administrative state is disabled.
no
Displays NTP server state of this node.
Displays stratum level of this node.
yes
— The operational state is disabled.
no
Displays the authentication requirement
IP address of this node or a 4-character ASCII code showing the state.
Displays the number of authentication errors.
Displays the number of authentication errors ignored.
Displays the number of key identification errors .
Displays the number of authentication key type errors.
The peer is rejected and will not be used for synchronization. Rejection
reasons could be the peer is unreachable, the peer is synchronized to
this local server so synchronizing with it would create a sync loop, or
the synchronization distance is too large. This is the normal startup
state.
Description
— NTP is enabled.
— Administrative state is enabled.
— The operational state is enabled.
Show Commands
Page 431