Alcatel-Lucent 7450 ESS-12 Configuration Manual page 211

Show Commands
Table 20: Show BOF Output Fields (Continued)
wait
autonegotiate
duplex
speed
console speed
dns domain
uplinkA-address
uplinkA-port
uplinkA-route
uplinkA-vlan
uplinkB-address
uplinkB-port
uplinkB-route
uplinkB-vlan
uplink-mode
no-service-ports
use-expansion-
card-type
Sample Output
A:ALA-1# show bof cf3:
=====================================================================
BOF on cf3:
=====================================================================
autonegotiate
primary-image
primary-config
secondary-image
secondary-config cf1:/config.cfg
address
address
primary-dns
Page 204
Label
The time configured for the boot to pause while waiting for console
input.
No autonegotiate — Autonegotiate not enabled.
autonegotiate — Autonegotiate is enabled.
half — Specifies that the system uses half duplex.
full — Specifies that the system uses full duplex.
The speed of the CPM Ethernet interface.
The console port baud rate.
The domain name used when performing DNS address resolution.
Displays the Uplink-A IP address.
Displays the primary port to be used for auto-boot.
Displays the static route associated with Uplink-A.
Displays the VLAN ID to be used on Uplink-A.
Displays the Uplink-B IP address.
Displays the secondary port to be used for auto-boot.
Displays the static route associated with Uplink-B.
Displays the VLAN ID to be used on Uplink-B.
This parameter displays the uplink mode of the device.
Displays the ports on which service traffic is not processed.
Displays the expansion card type.
ftp://test:test@192.168.xx.xx/./both.tim
ftp://test:test@192.168.xx.xx/./1xx.cfg
cf1:/i650/
192.168.xx.xxx/20 active
192.168.xx.xxx/20 standby
192.168.xx.xxx
7450 ESS OS Basic System Configuration Guide
Description