Table of Contents
Advertisement
Press the talk key. You will hear the dial tone and the talk icon appears on the
screen:
Enter the telephone number. After entering the last digit, the telephone
connection is being made and you will hear the ring tone. As soon as the
other party picks up the phone, you can start your conversation.
Alternatively you may follow these steps:
Lift the handset from the base station.
Enter the telephone number. You may correct the entry by pressing the
cancel key
Press the talk key. The Vtech GEMINI will send the telephone number to the
network. After the connection is established you will hear the ring tone.
•
Note
Your Vtech GEMINI supports the entry of telephone numbers with a
maximum of 24 digits.
When entering more than 16 digits the additional digits are displayed
on the second line of the display.
•
Your Vtech GEMINI offers several other means to dial telephone
numbers (e.g. using the phonebook. For details refer to page 14.
•
You may also make internal calls. Refer to page 21 for more details.
Answering a telephone call
When someone is calling you, you will hear the ring tone and the number (or name) of the calling party is displayed on the Vtech
GEMINI handset. Not all service providers support this so-called CLIP service. So ask your service provider about the availability and
additional charges of service.
To answer a telephone call you simply lift the handset from the base station or you press the talk key
•
Note
Your Vtech GEMINI handset displays the name of the calling party
(instead of the telephone number) only if you have previously entered
this telephone number in the phonebook.
•
The calling party may have restricted its identity. In this case the name
or number will not be shown. The display will simply
read:
•
Incoming calls are signalled acoustically on both the handset and the
base station. You may change the volume and melody of these ring
tones individually (refer to pages 37 and 41).
Ending a telephone call
To end a telephone call you simply press the talk key
standby mode.
Missed calls
If you had one or more unanswered calls during your absence the handset display shows
message key
is blinking to indicate that you missed one or more calls.
which deletes the last digit.
Incoming Call !
and the telephone connection is broken. The handset returns to the
.
New calls !
In addition, the
Advertisement
Table of Contents
