VTech GEMINI User Manual page 43

•
80, 100, 120, 180, 250, 300 or 600 msec
Confirm with the «OK» softkey. The new flash time is set.
Press the cancel key for approx. 2 seconds to return to the standby mode.
.....
Note The flash time setting is stored in the base station. This means that each
change of the flash time is immediately available to all other handsets which
are logged on to the same base station.
Resetting the base station to factory settings
With this procedure you can restore the base station settings to factory settings.
Open the menu by pressing the «Menu» softkey.
Select the menu entry
Select the menu entry
Select the menu entry
The display shows entry
The settings in the handset are reset to factory defaults.
Enter the PIN code and confirm with the «OK» softkey. The settings in the
base station are reset to factory defaults.
Press the cancel key for approx. 2 seconds to return to the standby mode.
.....
The following settings are affected when the base station is reset:
BS Setting Factory default
Ring tone volume High (level 5)
Ring tone melody Melody 1
Flash time 80 msec
Call Log Empty
Network access code none
PIN code 0000
Please note that resetting the base station will not reset the
PIN code! So make sure that you remember the PIN code in
case you have changed this!
VIP Phonebook Reset to predefined values.
Network codes Reset to predefined values.
•
Note
•
Settings
and press the «OK» softkey.
BS Settings
Reset BS
and press the «OK» softkey.
Reset HS?
Refer to page 45 for more information on the supplementary
network services and the corresponding network codes.
To reset the handset refer page 38.
and press the «OK» softkey.
.Confirm with the «Yes» softkey.