Incoming Calls; Ringing; Answering The Incoming Call; Terminating The Incoming Call - VTech PDL GX Manual

V
TECH
TITLE PDL GX Internal Product Specification
MODEL PDL GX

3.7 Incoming Calls

3.7.1 Ringing

Both the base and handset have provision to indicate an incoming call once a power ringing signal from
the CO has been detected. The base IN USE LED will flash at a rate of 16 Hz during the ON cycle of the
power ringing signal. If the handset is idle, and the user has not pre-dialed any digits, the handset will
display:
The LCD back light will come on as soon as ringing has been detected and ringing and will follow the
power ring signal cadence. This message will persist while the CO power ringing signal is active and for 5
more seconds after the last ring signal is received. However, the message will be immediately overwritten
by an incoming CID message if received. The handset will ring using the programmed ringer type and
level selected in Setup Mode.

3.7.2 Answering the Incoming Call

The user is provided with a quick method of answering the incoming call by pressing any key on the
handset (except the OFF key) once ringing has been detected and if the phone is in the idle state (no
menus active). This feature allows the user to answer the call without having to find the PHONE key
which may be difficult in a low ambient light condition.
If the user has any menus are active when the phone rings, the user must press the PHONE key to
answer the call.

3.7.3 Terminating the Incoming Call

The user can press the OFF key when the telephone is off hook to terminate the call or by simply cradling
the handset back into its base. Pressing the OFF key in any menu selection mode will not hang up the
call since it will return the user to the menu.
When the handset is returned to the cradle the base CHARGING LED will be lit RED to indicate the
handset is being charged.
Reference: PRC 00DM
This document is proprietary to V
Specifications are preliminary and are subject to change without notice.
E
NGINEERING
JODPNJOH JODPNJOH
JODPNJOH JODPNJOH
DBMM DBMM DBMM DBMM
Revision: 3.0
E C L
TECH NGINEERING ANADA
C L
ANADA
.
TD
IMITED
Page: 25 of 56
26649