Table of Contents
Advertisement
Press this softkey to open the list of available internal destinations (i.e. other
handsets which are logged on to the base station).
Select the internal destination you want to call from the list
Intern 2
(e.g.
Conduct your internal inquiry conversation.
You can switch between both parties by pressing the «Brokering» softkey.
You can also enter into a 3-party conference call by pressing the
«Conference» softkey.
•
Note
If the other internal party hangs up first, you are again connected to
your original external party. If however, you end this inquiry first by
pressing the talk key
to the remaining internal party.
•
Only one single internal call can be made at any time.
Making an external inquiry call
An external inquiry call is performed in the telephone network (supplementary network service). This means that you will have to
verify that this service is available from your service provider and that this service is activated with a flash signal. Make sure that the
correct flash signal period is programmed in your Vtech GEMINI (refer to page 42).
You are conducting an external call and you want to call another external
party without ending the first conversation.
Start the external inquiry call by pressing the R-key (flash key).
If this service is supported by your service provider you will hear the dial tone.
Now, enter the external telephone number for your inquiry (or select a number
e.g. from the phonebook).
You now have two (external) calls at the same time, one of which is on hold.
You can switch between both parties by pressing the «Brokering» softkey.
You can also enter into a 3-party conference call by pressing the
«Conference» softkey.
•
Note
If you end this inquiry by pressing the talk key
conversation is ended and your handset starts ringing indicating that
you still have another call holding. Press again the talk key to switch
back to this conversation.
•
It is not possible to make an external inquiry if you already are in an
internal conversation.
Transferring a call
If you have made an internal inquiry (refer to page 25) and thus you have two calls at the same time (one call on hold), then you may
want to connect (transfer) the external call to the internal call on the other handset.
You have two calls, one of which on hold (one external and one internal call).
Simply press the talk key to transfer the call and connect both parties.
) and press the «OK» softkey to dial this number.
, the external call is automatically connected
, the current
Advertisement
Table of Contents
