Multiple Handsets; Deregistering The Handset - VTech GEMINI User Manual

Multiple handsets

Registering ( logging-on) the handset
With the Vtech GEMINI you can operate up to 5 handsets on the same base station. This allows you to make internal calls between
handsets free of charge. For each handset a procedure must be followed which sets up a radio connection between the base station
and the respective handset. This procedure is called „Log on" and is described hereafter:
Press the paging key on the base station for approx. 10 seconds until you
hear a confirmation tone. The base station is now ready to accept a new
handset.
Open the menu by pressing the «Menu» softkey.
Select the menu entry
Select the menu entry
Select Base station A
If you are using more than one base station, you may select another base
station e.g. B, C or D.
Press the «OK» softkey. The display reads
that the handset is trying to establish a radio connection with the base station.
If the base station was found, then you are requested to enter the system PIN
code of that base station.
Confirm with the «OK» softkey. The handset is now logged on to this base
station. The display will reflect this by showing both the
If the log-on procedure was successful, the display will show the name as well as the internal number of the handset
INTERN 2
e.g. . The internal number of the handset is automatically assigned by the base station and cannot be changed.
Note To make it easier to identify the handset, you may change the name of the
handset e.g. to „PETER" or „MARY" (refer to page 38).
Register (log-on) to multiple base stations
You can also log on your handset to multiple base stations (max. 4). This is useful e.g. if you have an Vtech GEMINI base station at
home and another Vtech GEMINI base station at work. When you log on your handset to both these base stations than you can take
this handset with you from home to work and be able to make telephone calls at both locations with just one handset.
In this example you might select base station A for the one at home and base station B for the one at work. In the log-on procedure
the handset display indicates the base stations to which you are already logged on by an asterisk:

Deregistering the handset

Open the menu by pressing the «Menu» softkey.
Select the menu entry
Select the menu entry
Enter the system PIN code of the base station and press the «OK» softkey.
Select the internal number of the handset to log off, e.g.
confirm with the «OK» softkey.
The display shows
handset with the selected internal number is logged off from the base station.
Settings and press the «OK» softkey.
Log-on HS
and press the «OK» softkey.
to log the handset on to your base station.
Searching BS
Settings
and press the «OK» softkey.
Log off HS and press the «OK» softkey.
Log off? Again confirm with the «OK» softkey. The
indicating
and symbols.
INTERN 2
and
Base station A *