Fcc Part - VTech GEMINI User Manual

FCC, ACTA and IC Regulations
• In to event shall VTech be liable for any indirect, special, incidental, consequential, or similar damages (including,
but not limited to lost profits or revenue, inability to use the product, or other associated equipment, the cost of
substitute equipment, and claims by third parties) resulting from the use of this product, some states do
not allow the exclusion or limitation of incidental or consequential damages, so the above limitation or exclusion may
not apply to you.
FCC, ACTA and IC Regulations
This equipment complies with Parts 15 of the Federal Communications Commission (FCC) rules for the United States.
It also complies with regulations RSS210 and CS-03 of Industry and Science Canada. Operation is subject to the
following two conditions: (1) this device may not cause interference, and (2) this device must accept any interference,
including interference that may cause undesired operation of the device.
A label is located on the underside of the Base Unit containing either the FCC registration number and Ringer
Equivalence Number (REN) or the IC registration number and Load Number. You must, upon request, provide this
information to your local telephone company.
This equipment is compatible with inductively coupled hearing aids. Should you experience trouble with this telephone
equipment, please contact:
VTech Communications Inc
CUSTOMER SERVICE at 1-800-595-9511. In Canada, call VTech Telecommunications Canada Ltd. at 1-800-267-
7377.
For repair/warranty information. The telephone company may ask you to disconnect this equipment from the line
network until the problem has been corrected.

FCC Part 15

Warning: Changes or modifications to this unit not expressly approved by the party responsible for compliance could
void the user's authority to operate the equipment.
The equipment has been tested and found to comply with part 15 of the FCC rules. These limits are designed to
provide reasonable protection against harmful interference in a residential installation. This equipment generates,
uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may
cause harmful interference to radio communications.
However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause
harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the
user is encouraged to try and correct the interference by one or more of the following measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment into an outlet or on a circuit different from that to which the receiver is connected.
• Consult the dealer or an experienced radio/TV technician for help.
To ensure safety of users, the FCC has established criteria for the amount of radio frequency energy that can be
safely absorbed by a user or bystander according to the intended usage of the product. This product has been tested
and found to comply with the FCC criteria. The handset has such a low power that it does not require testing. It may
be safely held against the ear of the user. The base unit shall be installed & used such that parts of the user's body
other than the hands should be maintained at a comfortable distance of approximately 20 cm or more.
FCC and ACTA Information
If this equipment was approved for connection to the telephone network prior to July 23, 2001, it complies with Part 68
of the Federal Communications Commission (FCC) rules. If the equipment was approved after that date, it complies
with the Part 68 rules and with Technical Requirements for Connection of Equipment to the Telephone Network
adopted by the Administrative Council for Terminal Attachments (ACTA). We are required to provide you with the
following information.
1. Product identifier and REN information
The label on the back or bottom of this equipment contains, among other things, an identifier indicating product
approval and the Ringer Equivalence Number (REN). This information must be provided to your local telephone
company upon request. For equipment approved prior to July 23, 2001, the product identifier is preceded by
the phrase "FCC Reg No." and the REN is listed separately. For equipment approved after that date, the product