VTech GEMINI User Manual page 19

Note The entire redial list is also deleted when the handset is reset (refer to page
38).
Store number from the redial list in the phonebook
Press the «Redial» softkey. The first entry in the redial list is displayed.
Scroll to the desired entry using the navigation keys.
Open the redial list administration menu by pressing the «Options» softkey.
Select the menu entry
softkey.
The display reads
finish by pressing the «Store» softkey. The display briefly
shows Entry stored !
Press the cancel key for approx. 2 seconds to return to the standby mode.
.....
Dialling from the Call Log
If the CLIP service is supported by your service provider (i.e. if the telephone number of the calling party is made available) then any
unanswered calls will be stored in the Call Log. This Call Log contains up to 20 entries. If the Call Log is full, then the newest entry
overwrites the oldest one.
The handset display shows
blinking to indicate that you missed one or more calls.
Dialling a telephone number from the Call Log
The handset display shows
Press the message key. The most recent unanswered call is displayed.
Scroll to the desired entry using the navigation keys.
Press the talk key. The corresponding telephone number is dialled.
or
Open the menu by pressing the «Menu» softkey.
Select the menu entry
Select the menu entry
Scroll to the desired entry using the navigation keys.
Press the talk key. The corresponding telephone number is dialled.
Note With PBX telephone systems:
Dialling from the Call Log works properly only if the PBX system automatically
inserts first any required network access digit! Refer to the respective PBX
user documentation for more information.
Managing the Call Log
Show details of an unanswered call
Press the message key.
Select the menu entry
Store phonebook
Enter name: Enter the corresponding name and
. The entry is now stored in the phonebook.
New calls !
if you have any new unanswered calls. In addition, the message key
New calls !
Messages
and press the «OK» softkey.
Call Log and press the «OK» softkey.
Call Log
and press the «OK» softkey.
and press the «OK»
is