Ipv6 Pim-Ssm Configuration Example - HP FlexNetwork 7500 Series Configuration Manual

RPF interface: Vlan-interface102
List of 2 DF interfaces:
# Display information about the DF for IPv6 multicast forwarding on Switch C.
[SwitchC] display ipv6 multicast forwarding df-info
Total 1 RP, 1 matched
00001. RP address: 6001::1
Flags: 0x0
Uptime: 00:07:21
RPF interface: LoopBack0
List of 2 DF interfaces:
# Display information about the DF for IPv6 multicast forwarding on Switch D.
[SwitchD] display ipv6 multicast forwarding df-info
Total 1 RP, 1 matched
00001. RP address: 6001::1
Flags: 0x0
Uptime: 00:05:12
RPF interface: Vlan-interface103
List of 2 DF interfaces:

IPv6 PIM-SSM configuration example

Network requirements
As shown in
•
OSPFv3 runs on the network.
•
Receivers receive VOD information through multicast. The receiver groups of different
organizations form stub networks, and one or more receiver hosts exist in each stub network.
The entire IPv6 PIM domain operates in the SSM mode.
•
Host A and Host C are IPv6 multicast receivers on two stub networks N1 and N2.
•
The SSM group range is FF3E::/64.
•
MLDv2 runs between Switch A and N1 and between Switch B, Switch C, and N2.
1: Vlan-interface101
2: Vlan-interface200
1: Vlan-interface102
2: Vlan-interface103
1: Vlan-interface300
2: Vlan-interface400
Figure 110:
351