Displaying And Maintaining Ipv6 Pim Snooping - HP FlexNetwork 7500 Series Configuration Manual

Step
(Optional.) Set the aging
7.
time for global neighbor
ports on the new active
MPU after an
active/standby switchover.
(Optional.) Set the aging
8.
time for global
downstream ports and
global router ports on the
new active MPU after an
active/standby switchover.

Displaying and maintaining IPv6 PIM snooping

Execute display commands in any view and reset commands in user view.
Task
Display IPv6 PIM snooping neighbor
information (in standalone mode).
Display IPv6 PIM snooping neighbor
information (in IRF mode).
Display IPv6 PIM snooping router
port information (in standalone
mode).
Display IPv6 PIM snooping router
port information (in IRF mode).
Display IPv6 PIM snooping routing
entries (in standalone mode).
Display IPv6 PIM snooping routing
entries (in IRF mode).
Display statistics for the IPv6 PIM
messages learned through IPv6 PIM
snooping.
Clear statistics for the IPv6 PIM
messages learned through IPv6 PIM
snooping.
IPv6 PIM snooping configuration example
Network requirements
As shown in
•
OSPFv3 runs on the network.
•
Source 1 sends IPv6 multicast data to IPv6 multicast group FF1E::101, and Source 2 sends
IPv6 multicast data to IPv6 multicast group FF2E::101.
•
Receiver 1 belongs to IPv6 multicast group FF1E::101, and Receiver 2 belongs to IPv6
multicast group FF2E::101.
•
Router C and Router D run MLD on GigabitEthernet 1/0/1.
Command
ipv6 pim-snooping
graceful-restart
neighbor-aging-time interval
ipv6 pim-snooping
graceful-restart join-aging-time
interval
Figure 79:
Command
display ipv6 pim-snooping neighbor [ vlan vlan-id ] [ slot
slot-number ] [ verbose ]
display ipv6 pim-snooping neighbor [ vlan vlan-id ] [ chassis
chassis-number slot slot-number ] [ verbose ]
display ipv6 pim-snooping router-port [ vlan vlan-id ] [ slot
slot-number ]
display ipv6 pim-snooping router-port [ vlan vlan-id ] [ chassis
chassis-number slot slot-number ]
display ipv6 pim-snooping routing-table [ vlan vlan-id ] [ slot
slot-number ] [ verbose ]
display ipv6 pim-snooping routing-table [ vlan vlan-id ]
[ chassis chassis-number slot slot-number ] [ verbose ]
display ipv6 pim-snooping statistics
reset ipv6 pim-snooping statistics
257
Remarks
The default setting is 105
seconds.
A global neighbor port is a Layer
2 aggregate interface that acts as
a neighbor port.
The default setting is 210
seconds.
A global downstream port or a
global router port is a Layer 2
aggregate interface that acts as a
downstream port or router port.