Configuring Static Ports - HP FlexNetwork 7500 Series Configuration Manual

globally.
Setting the aging timers for dynamic ports in a VLAN
Step
Enter system view.
1.
Enter VLAN view.
2.
Set the aging timer for
3.
dynamic router ports in the
VLAN.
Set the aging timer for
4.
dynamic member ports in the
VLAN.

Configuring static ports

You can configure the following types of static ports:
•
Static member port—When you configure a port as a static member port for a multicast group,
all hosts attached to the port will receive multicast data for the group.
The static member port does not respond to IGMP queries. When you complete or cancel this
configuration on a port, the port does not send an unsolicited IGMP report or leave message.
•
Static router port—When you configure a port as a static router port for a multicast group, all
multicast data for the group received on the port will be forwarded.
To configure static ports:
Step
Enter system view.
1.
Enter Layer 2 Ethernet
2.
interface view or Layer 2
aggregate interface view.
Configure the port as a static
3.
port.
Configuring a port as a simulated member host
When a port is configured as a simulated member host, it is equivalent to an independent host in the
following ways:
•
It sends an unsolicited IGMP report when you complete the configuration.
•
It responds to IGMP general queries with IGMP reports.
•
It sends an IGMP leave message when you cancel the configuration.
Command
system-view
vlan vlan-id
igmp-snooping
router-aging-time interval
igmp-snooping
host-aging-time interval
Command
system-view
interface interface-type
interface-number
•
Configure the port as a static
member port:
igmp-snooping
static-group group-address
[ source-ip source-address ]
vlan vlan-id
•
Configure the port as a static
router port:
igmp-snooping
static-router-port vlan
vlan-id
20
Remarks
N/A
N/A
The default setting is 260
seconds.
The default setting is 260
seconds.
Remarks
N/A
N/A
By default, a port is not a static
member port or static router port.