Configuring Common Ipv6 Pim Features - HP FlexNetwork 7500 Series Configuration Manual

•
When a member of an IPv6 multicast group in the IPv6 SSM group range sends an MLDv1
report message, the device does not trigger a (*, G) join.
Configuration procedure
To configure an IPv6 SSM group range:
Step
Enter system view.
1.
Enter IPv6 PIM view.
2.
Configure the IPv6 SSM
3.
group range.

Configuring common IPv6 PIM features

Configuration task list
Tasks at a glance
(Optional.)
(Optional.)
(Optional.)
(Optional.)
(Optional.)
(Optional.)
(Optional.)
(Optional.)
Configuration prerequisites
Before you configure common IPv6 PIM features, complete the following tasks:
•
Configure an IPv6 unicast routing protocol so that all devices in the domain can interoperate at
the network layer.
•
Configure IPv6 PIM-DM or IPv6 PIM-SSM.
Configuring an IPv6 multicast source policy
This feature enables the device to filter IPv6 multicast data by using an ACL that specifies the IPv6
multicast sources and the optional groups. It filters not only IPv6 multicast data packets but also IPv6
PIM register messages with IPv6 multicast data encapsulated. This also reduces the IPv6 multicast
traffic on the network.
To configure an IPv6 multicast source policy:
Step
Enter system view.
1.
Configuring an IPv6 multicast source policy
Configuring an IPv6 PIM hello policy
Configuring IPv6 PIM hello message options
Configuring common IPv6 PIM timers
Setting the maximum size of each join or prune message
Enabling BFD for IPv6 PIM
Enabling IPv6 PIM passive mode
Enabling IPv6 PIM NSR
Command
system-view
ipv6 pim
ssm-policy acl6-number
Command
system-view
329
Remarks
N/A
N/A
The default range is FF3x::/32,
where x can be any valid scope.
Remarks
N/A