HP FlexNetwork 7500 Series Configuration Manual page 349

•
VOD streams are sent to receiver hosts in multicast. The receivers of different subnets form
stub networks, and at least one receiver host exist in each stub network. The entire IPv6
PIM-SM domain contains only one BSR.
•
Host A and Host C are multicast receivers in the stub networks N1 and N2.
•
Specify VLAN-interface 102 on Switch E as a C-BSR and a C-RP. The C-RP is designated to
the IPv6 multicast group range FF0E::101/64. Specify VLAN-interface101 of Switch D as the
static RP on all the switches to back up the dynamic RP.
•
MLDv1 runs between Switch A and N1, and between Switch B, Switch C, and N2.
Figure 107 Network diagram
Table 22 Interface and IPv6 address assignment
Device
Switch A
Switch A
Switch A
Switch B
Switch B
Switch C
Switch C
Configuration procedure
Assign an IPv6 address and prefix length to each interface according to
1.
shown.)
Configure OSPFv3 on all switches in the IPv6 PIM-SM domain. (Details not shown.)
2.
Enable IPv6 multicast routing, MLD, and IPv6 PIM-SM:
3.
Interface IPv6 address
Vlan-int100 1001::1/64
Vlan-int101 1002::1/64
Vlan-int102 1003::1/64
Vlan-int200 2001::1/64
Vlan-int103 2002::1/64
Vlan-int200 2001::2/64
Vlan-int104 3001::1/64
Device Interface
Switch D Vlan-int300
Switch D Vlan-int101
Switch D Vlan-int105
Switch E Vlan-int104
Switch E Vlan-int103
Switch E Vlan-int102
Switch E Vlan-int105
339
IPv6 address
4001::1/64
1002::2/64
4002::1/64
3001::2/64
2002::2/64
1003::2/64
4002::2/64
Table 22. (Details not