HP FlexNetwork 7500 Series Configuration Manual page 307

Configure the MLD SSM mapping feature on Router D so that the receiver host will receive IPv6
multicast data only from Source 1 and Source 3.
Figure 92 Network diagram
Source 2
Source 1
Table 19 Interface and IPv6 address assignment
Device
Source 1
Source 2
Switch A
Switch A
Switch A
Switch B
Switch B
Switch B
Configuration procedure
Assign an IPv6 address and prefix length to each interface according to
1.
shown.)
Configure OSPFv3 on the switches in the IPv6 PIM-SM domain. (Details not shown.)
2.
Enable IPv6 multicast routing, and enable IPv6 PIM-SM and MLD:
3.
# On Switch D, enable IPv6 multicast routing.
<SwitchD> system-view
[SwitchD] ipv6 multicast routing
[SwitchD-mrib6] quit
# Enable MLDv2 on the receiver-side interface (VLAN-interface 400).
[SwitchD] interface vlan-interface 400
[SwitchD-Vlan-interface400] mld enable
[SwitchD-Vlan-interface400] mld version 2
[SwitchD-Vlan-interface400] quit
# Enable IPv6 PIM-SM on the other interfaces.
[SwitchD] interface vlan-interface 103
[SwitchD-Vlan-interface103] ipv6 pim sm
[SwitchD-Vlan-interface103] quit
[SwitchD] interface vlan-interface 104
[SwitchD-Vlan-interface104] ipv6 pim sm
Switch B
Vlan-int200 Vlan-int102
Vlan-int101
IPv6 PIM-SM
Vlan-int101
Vlan-int100 Vlan-int104
Switch A
Interface IPv6 address
— 1001::1/64
— 2001::1/64
Vlan-int100 1001::2/64
Vlan-int101 1002::1/64
Vlan-int104 1003::1/64
Vlan-int200 2001::2/64
Vlan-int101 1002::2/64
Vlan-int102 2002::1/64
Switch C
Vlan-int300
Vlan-int102
Vlan-int103
Vlan-int103
Vlan-int400
Vlan-int104
Switch D
Device
Source 3
Receiver
Switch C
Switch C
Switch C
Switch D
Switch D
Switch D
297
Source 3
Receiver
Interface IPv6 address
— 3001::1/64
— 4001::1/64
Vlan-int300 3001::2/64
Vlan-int103 3002::1/64
Vlan-int102 2002::2/64
Vlan-int400 4001::2/64
Vlan-int103 3002::2/64
Vlan-int104 1003::2/64
Table 19. (Details not