Configuring Static Ports - HP FlexNetwork 7500 Series Configuration Manual

Setting the aging timers for dynamic ports in a VLAN
Step
Enter system view.
1.
Enter VLAN view.
2.
Set the aging timer for
3.
dynamic router ports in the
VLAN.
Set the aging timer for
4.
dynamic member ports in the
VLAN.

Configuring static ports

You can configure the following types of static ports:
•
Static member port—When you configure a port as a static member port for an IPv6 multicast
group, all hosts attached to the port will receive IPv6 multicast data for the group.
The static member port does not respond to MLD queries. When you complete or cancel this
configuration, the port does not send an unsolicited report or done message.
•
Static router port—When you configure a port as a static router port for an IPv6 multicast
group, all IPv6 multicast data for the group received on the port will be forwarded.
To configure static ports:
Step
Enter system view.
1.
Enter Layer 2 Ethernet
2.
interface view or Layer 2
aggregate interface view.
Configure the port as a static
3.
port.
Configuring a port as a simulated member host
When a port is configured as a simulated member host, it is equivalent to an independent host in the
following ways:
•
It sends an unsolicited MLD report when you complete the configuration.
•
It responds to MLD general queries with MLD reports.
•
It sends an MLD done message when you remove the configuration.
Command
system-view
vlan vlan-id
mld-snooping
router-aging-time interval
mld-snooping host-aging-time
interval
Command
system-view
interface interface-type
interface-number
•
Configure the port as a static
member port:
mld-snooping static-group
ipv6-group-address
[ source-ip
ipv6-source-address ] vlan
vlan-id
•
Configure the port as a static
router port:
mld-snooping
static-router-port vlan
vlan-id
235
Remarks
N/A
N/A
The default setting is 260
seconds.
The default setting is 260
seconds.
Remarks
N/A
N/A
By default, a port is not a static
member port or static router port.