Configuring Multicast Source Registration - HP FlexNetwork 7500 Series Configuration Manual

To disable BSM semantic fragmentation:
Step
Enter system view.
1.
Enter PIM view.
2.
Disable BSM semantic
3.
fragmentation.
NOTE:
Generally, a BSR performs BSM semantic fragmentation according to the MTU of its BSR interface.
For BSMs originated due to learning of a new PIM neighbor, semantic fragmentation is performed
according to the MTU of the interface that sends the BSMs.

Configuring multicast source registration

A PIM register policy enables an RP to filter register messages by using an ACL that specifies the
multicast sources and groups. The policy limits the multicast groups to which the RP is designated. If
a register message is denied by the ACL or does not match the ACL, the RP discards the register
message and sends a register-stop message to the source-side DR. The registration process stops.
You can configure the device to calculate the checksum based on the entire register message to
ensure information integrity of a register message in the transmission process. If a device that does
not support this feature is present on the network, you can configure the device to calculate the
checksum based on the register message header.
The RP sends a register-stop message to the source-side DR in either of the following conditions:
•
The RP stops serving the receivers for a multicast group. The receivers do not receive multicast
data addressed to the multicast group through the RP.
•
The RP receives multicast data that travels along the SPT.
After receiving the register-stop message, the DR stops sending register messages encapsulated
with multicast data and starts a register-stop timer. Before the register-stop timer expires, the DR
sends a null register message (a register message without encapsulated multicast data) to the RP
and starts a register probe timer. If the DR receives a register-stop message before the register
probe timer expires, it resets its register-stop timer. Otherwise, the DR starts sending register
messages with encapsulated data again.
On all C-RP routers, perform the following tasks:
•
Configure a PIM register policy.
•
Configure the routers to calculate the checksum based on the entire register messages or the
register message header.
To configure multicast source registration:
Step
Enter system view.
1.
Enter PIM view.
2.
Configure a PIM register
3.
policy.
Command
system-view
pim [ vpn-instance
vpn-instance-name ]
undo bsm-fragment enable
Command
system-view
pim [ vpn-instance
vpn-instance-name ]
register-policy acl-number
114
Remarks
N/A
N/A
By default, BSM semantic
fragmentation is enabled.
Remarks
N/A
N/A
By default,no PIM register policy
exists.