Inconsistent Membership Information On The Routers On The Same Subnet - HP FlexNetwork 7500 Series Configuration Manual

Use the display current-configuration command to verify that the IPv6 multicast routing is
2.
enabled. If it is not enabled, use the ipv6 multicast routing command in system view to enable
IPv6 multicast routing. In addition, verify that MLD is enabled on the associated interfaces.
Use the display mld interface command to verify that the MLD version on the interface is
3.
lower than that on the host.
Use the display current-configuration interface command to verify that no ACL has been
4.
configured to filter the reports sent by the host to the IPv6 multicast group G.
If the problem persists, contact Hewlett Packard Enterprise Support.
5.
Inconsistent membership information on the routers on the
same subnet
Symptom
Different memberships are maintained on different MLD routers on the same subnet.
Solution
To resolve the problem:
Use the display current-configuration command to verify the MLD information on the
1.
interface.
Use the display mld interface command on all routers on the same subnet to check the MLD
2.
timers for inconsistent configurations.
Use the display mld interface command to verify that the routers are running the same MLD
3.
version.
If the problem persists, contact Hewlett Packard Enterprise Support.
4.
300