Troubleshooting Ipv6 Pim Snooping - HP FlexNetwork 7500 Series Configuration Manual

•
Switch A will forward the multicast data intended for IPv6 multicast group FF2E::101 to only
Router D.

Troubleshooting IPv6 PIM snooping

This section describes common IPv6 PIM snooping problems and how to troubleshoot them.
IPv6 PIM snooping does not work on a Layer 2 device
Symptom
IPv6 PIM snooping does not work on a Layer 2 device.
Solution
To resolve the problem:
Use the display current-configuration command to display information about MLD snooping
1.
and IPv6 PIM snooping.
If MLD snooping is not enabled, enable MLD snooping globally, and then enable MLD snooping
2.
and IPv6 PIM snooping for the VLAN.
If IPv6 PIM snooping is not enabled, enable IPv6 PIM snooping for the VLAN.
3.
If the problem persists, contact Hewlett Packard Enterprise Support.
4.
261