Advertisement
8. Gently push retaining clips outwards and
remove rear circuit board. This is the
internal antenna which will no longer be
needed.
Back View
9. Connect the internal antenna cable from
the ZeroWire to the radio module.
10. Connect a high gain antenna to the antenna
socket shown below and retest signal level.
11. Move the ZeroWire or the antenna to
another location if the signal is still too
low.
Document: 230273
21/10/2014
Completing Installation
12. Insert the whole radio module in to the
ZeroWire taking care not to crimp any
cables.
13. Replace the modem cover on the ZeroWire
Specifications
Power: Provided by panel
System Current Draw: 750 mA max at 9V
Operating Temperature Range 0° to 49°C
(32° to 120°F)
Storage
Temperature:
(-30° to 120°F)
Maximum
Humidity:
humidity non-condensing
External connector: MMCX
Approvals:
FCC ID: XPYSARAU260
IC: 8595A-SARAU260ID
-34°
to
60°C
90%
relative
Page 2
Advertisement
